Instruction Manual

Methods
Eppendorf BioPhotometer
®
D30
English (EN)
34
6.4 Method procedure
A method procedure is composed of a maximum of 5 steps. The currently active step is highlighted visually.
After the last step, print & export, of a measuring series, the start of a new measuring series is offered as a
next step. It once again starts with the sample measurement.
Use the [Next >] and [< Back] softkeys to navigate between method steps. With [Abort] and [Finish] you can
cancel or finish the measuring procedure. The name of this softkey changes from [Abort] to [Finish] after
the first sample measurement.
Autoprint Selection:
on | off
Printing a measuring result immediately following
measurement with the thermal printer.
Only the main result data will be printed. To output detailed
data, the required data packets can be compiled and printed in
the print & export method step at the end of a measuring
series.
Wizard: the wizard at the top of the display will take
you through the method procedure. The currently
active method step is highlighted.
Method step Explanation
Check parameters Check method parameters. Carry out changes if required.
Measure standards Only for methods with standard evaluation:
Measure and evaluate standards. Alternatively, the last saved standard
evaluation can be used.
Measure samples Measuring samples
Process results Only for methods of the Nucleic acids group: postprocess results (conversion
of the concentration results).
Print & export Assemble data packets for printing or exporting the data.
Parameter Entry Explanation