Manual

24
M1248-0051

C-76 Classic Water Bath Shaker Operating manual
6
6
O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
6.1 Starting the C-76
To initially start the shaker, turn the ON/OFF SWITCH on the side of shaker to the ON
position. If the Shaker begins to operate, the LED DISPLAY will track the speed as it
accelerates to the last entered setpoint. The shaking action may be stopped or started by
pressing the START/STOP KEY.
6.2 Continuous (Unlimited) Run
1. Press SELECT until the RPM INDICATOR is illuminated.
2. If the display indicates that the shaker is OFF, press the START/STOP KEY.
3. Press either σ or
τ
KEY to enter SET MODE (the SET INDICATOR will illuminate).
4. Set the speed by using the σ or
τ
KEY until the desired setpoint is displayed. Holding
the σ or
τ
KEY will cause the setting to change more rapidly.
NOTE:
The setpoint may be changed during a run without stopping the shaker by
following steps 2-4 above. During speed changes, a visual alarm (flashing
RPM INDICATOR) will flash until the speed returns to within 5 rpm of the
setpoint.
6.3 Checking Any Setpoint
1. Press SELECT until the desired indicator is illuminated.
2. Press either σ or τ KEY to enter the SET MODE and display the current setpoint.