Manual

19
New Brunswick Operating manual
5.2 Installation of Drive Arms and Platform
The SUSPENSION ARM KIT included in your shipment allows you to install a platform
in the bath. The kit includes a set of four each DRIVE ARMS, KNOBS,
LOCKWASHERS and PLATFORM SCREWS. The DRIVE ARMS attach to the
SUSPENSION ARM and are secured by a KNOB and LOCKWASHER (see Figure 6
below). The platform rests on the DRIVE ARMS inside the bath and is secured by the
PLATFORM SCREWS. The DRIVE ARMS and PLATFORM can be installed separately
or as an assembly.
Figure 6: Drive Arm Installation
When installing the DRIVE ARMS and/or PLATFORM, ensure that each DRIVE ARM is
perpendicular to the SUSPENSION ARM. The DRIVE ARMS can be adjusted or
removed by loosening the KNOBS that hold the arms in place. Ensure that each
KNOB, LOCKWASHER and DRIVE ARM is secured before installing a PLATFORM.
Place a PLATFORM on top of the DRIVE ARMS and align the holes in the PLATFORM
with the platform screw locations (see Figure 7) on the DRIVE ARMS. Install the
PLATFORM SCREWS and secure the PLATFORM in place as shown in Figure 8.
LOCKWASHERS (4)
P/N W2217-3120
SUSPENSION
ARM
DRIVE ARMS (4)
P/N M1248-0730
KNOBS (4)
P/N H-967