Instruction Manual

27
Innova 5000  M1196-0050 Operating Manual
5.4 Main Bearing Housing Assembly Replacement
If it becomes necessary to replace the main bearing housing assembly, the Service
Engineer will, with reference to Figures 7, 8 & 9 below:
1. Set the power switch to OFF position and disconnect the power cord.
2. Remove all platforms from the unit.
3. Remove all 16 bolts that hold the idler housing to the base.
4. Remove the four bolts that hold the main shaft to the the lower main housing.
Figure 7: Frame End View
5. Remove the frame from the unit by raising the unit up to disengage the locating
pin from the lower main housing.
LOWER
BEARING