Instruction Manual

19
Innova 5000  M1196-0050 Operating Manual
3
3
O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
3.1 Getting Started
To start the instrument, turn the power switch to the ON position.
When the shaker is running, the LED display will track the speed as it accelerates to
the last entered setpoint. The shaking action may be stopped or started by pressing the
START/STOP key.
NOTE:
At the higher speed ranges, we recommend that the platforms have a
30 percent minimum load to maintain a good balance condition.
3.2 Continuous (Unlimited) Run
1. If the LED displays OFF, press the START/STOP key.
2. Press the SELECT key until RPM is lit.
3. Press either σ or τ to enter Set mode (set indicator will light).
4. Set the speed by using the σ or τ key until the desired setpoint is displayed. Holding
the σ or τ key will cause the setting to change more rapidly.
The setpoint may be changed at any time during a run without stopping the shaker by
following steps 2-4. During speed changes, the alarm may sound until the speed returns
to within 5 RPM of the setpoint.
3.3 Checking Setpoints
To check any setpoint:
1. Press the SELECT key until the desired indicator is lit.
2. Press either σ or τ to enter the Set mode and display the current setpoint.
NOTE:
Holding the σ or τ key for more than 0.5 second causes the setpoint to
change. Should this occur, resetting will be necessary.