Manual

Product description

New Brunswick Digital Platform Shaker Innova® 2100/2150

English (EN)

3.4.2 Keypad

3.4.3 Status indicators

3.4.4 Function indicators

3.5 Platform assemblies

Neither the Innova 2100 nor the 2150 can be used without a platform. One must be purchased and installed

on your shaker prior to operation (see Platforms on p. 31).

The Innova 2100 can be used with a wide range of New Brunswick 28 cm x 33 cm (11 in × 13 in) platforms,

which will accept a variety of clamps for flasks, test tubes, etc.

The Innova 2150 can accommodate an even wider range of New Brunswick 30.5 cm × 40.6 cm (12 in x

16 in) platforms, which will accept a variety of clamps for flasks, test tubes, etc.

START/STOP • Starts and stops the drive

• Activates or stops timer when timed run is desired

Keys

• Adjusts the setpoint of a displayed parameter up or down

• Used to enter the SET mode for setpoint changes

SELECT • Changes the displayed parameter

• Temperature (°C) cannot be selected unless the temperature/remote monitoring

option is installed.

MAINT • Illuminates after 10000 hours of use. Indicates need for routine maintenance (see

Routine maintenance on p. 25)

SET Illuminates to indicate that:

• Shaker is in SET mode

• Setpoints are being displayed

• Setpoints can be altered

TIME • Illuminates to indicate that the timer is in operation

MUTE • Illuminates to indicate that the audible alarm is disabled

RPM Revolutions per minute shaking speed

HRS Time remaining

°C Temperature function (only activated of the temperature/monitor option is installed)

* This function is not active in the Innova 2100/2150