Specifications

InstallationP2-112A

Page 3-3

Easy Installation Procedure

The following must be completed before powering on your new system:

3-1. Configure Jumpers to match your hardware

3-2. Install memory chips

3-3. Install Pentium II Processor

3-4. Device Connectors

Section 3-1

Configure DIP Switch

P2-112A designs this motherboard with an ESDJ to make your installation fast and

easier.

The following will describe all of the ESDJ that you are required to set before moving

on to step 3-2.

Note: The ESDJ as depicted as shown (Figure 1) in their correct physical

orientation.

JP1 Clear CMOS

1-2 : Run Mode (default)

2-3 : Clear CMOS

JP4 Keyboard Power on Selection

1-2 : Disabled (default)

2-3 : Enabled