Specifications

BIOSEP-MVP4G
Page 4-11
4-4 Power Management Setup
Choose the “POWER MANAGEMENT SETUP” in the CMOS SETUP UTILITY
to display the following screen. This menu allows the user to modify the power
management parameters and IRQ signals. In general, these parameters should not be
changed unless it’s absolutely necessary.
Figure 5: Power Management Setup
You can only change the content of Doze Mode, Standby Mode, and Suspend Mode
when the Power Management is set to ‘User Define’.
Power Management: Use this to select your Power Management selection.
The default is User define.
Disabled: The system operates in NORMAL conditions (Non-GREEN), and
the Power Management function is disabled.
Max. saving: Maximum power savings. Inactivity period is 1 minute in each
mode.
Min. saving: Minimum power savings. Inactivity period is 1 hour in each
mode.
User define: Allows user to define PM Timers parameters to control power
saving mode.
ROM PCI/ISA BIOS (2A5LHPA9)
POWER MANAGEMENT SETUP
AWARD SOFTWARE, INC.
ACPI function : Enabled Primary INTR : ON
Power Management : User Define IRQ3 (COM 2) : Primary
PM Control by APM : Yes IRQ4 (COM 1) : Primary
Video off Method : V/H SYNC+Blank IRQ5 (LPT 2) : Primary
Video off After : Suspend IRQ6 (Floppy Disk) : Disabled
MODEM Use IRQ : 3 IRQ7 (LPT 1) : Primary
Doze Mode : Disable IRQ8 (RTC Alarm) : Disabled
Suspend Mode : Disable IRQ9 (IRQ2 Redir) : Primary
HDD Power Down : Disable IRQ10(Reserved) : Primary
Soft-off by PWRBTN : Delay 4 Sec IRQ11(Reserved) : Primary
PWRON After PW-Fail : Former-Status IRQ12(PS/2 Mouse) : Primary
** PM Events ** IRQ13 (CoPro) : Disabled
VGA : OFF IRQ14 (HDD) : Disabled
LPT & COM : LPT/COM IRQ15 (Rsv) : Disabled
HDD & FDD : NO
DMA/master : OFF
RTC Alarm Resume : Disabled
Modem Ring Resume : Disabled
Esc : Quit : Select Item
F1 : Help PU/PD/+/- : Modify
F5 : Old Values (Shift) F2 : Color
F7 : Load Setup Defaults
éé
éé
é
êê
êê
ê
èè
èè
è
çç
çç
ç