Specifications

BIOS EP-MVP4F

Page 4-16

4-6 Load Setup Defaults

The “LOAD SETUP DEFAULTS” function loads the system default data directly

from ROM and initializes the associated hardware properly. This function will be

necessary only when the system CMOS data is corrupted.

4-7 Integrated Peripherals

Figure 8: Integrated Peripherals

Note: If you do not use the Onboard IDE connector, then you will need to

set Onboard Primary PCI IDE: Disabled and Onboard Secondary

PCI IDE: Disabled

Note: The Onboard PCI IDE cable should be equal to or less than 18

inches (45 cm.).

IDE Prefetch Mode: Enable prefetching for IDE drive interfaces that support its

faster drive accesses. If uou are getting disk drive errors, change the setting to

omit the drive interface where the errors occur. Depending on the configuration

of your IDE subsystem, this field may not appear, and it does not appear when the

Internal PCI/IDE field, above, is Disabled.

The Choice: Enabled, Disabled.

ROM PCI/ISA BIOS(2A5LHPA9)

INTEGRATED PERIPHERALS

AWARD SOFTWARE, INC.

OnChip IDE Channel0 : Enabled Onboard Parallel Mode :ECP/EPP

OnChip IDE Channel1 : Enabled ECP Mode Use DMA :3

IDE Prefetch Mode : Enabled Parallel Port EPP Type : EPP1.9

IDE HDD Block Mode : Enabled Onboard Legacy Audio : Enabled

Primary Master PIO : Auto Sound Blaster :Disabled

Primary Slave PIO : Auto SB I/O Base Address :220H

Secondary Master PIO : Auto SB IRQ Select :IRQ5

Secondary Slave PIO : Auto SB DMA Select : DMA1

Primary Master UDMA : Auto MPU-401 I/O Address :330-333H

Primary Slave UDMA : Auto FM Port (388-38BH) :Disabled

Secondary MasterUDMA : Auto Game Port (200-207H) :Enabled

Secondary Slave UDMA : Auto

Onboard FDD Controller : Enabled

Onboard Serial Port 1 : Auto

Onboard Serial Port 2 : Auto

UART 2 Mode : Standard

Onboard Parallel Port : 378/IRQ7

Esc : Quit : Select Item

F1 : Help PU/PD/+/- : Modify

F5 : Old Values (Shift) F2 : Color

F7 : Load Setup Defaults

éé

êê

èè

çç