Specifications

BIOSEP-MVP4F
Page 4-11
4-4 Power Management Setup
Choose the “POWER MANAGEMENT SETUP” in the CMOS SETUP UTILITY to
display the following screen. This menu allows the user to modify the power
management parameters and IRQ signals. In general, these parameters should not
be changed unless it’s absolutely necessary.
Figure 5: Power Management Setup
ACPI Function: This option allows you to select ACPI Function.
The default is Enabled.
Enabled: Support ACPI function for new O.S
Disabled: No Support ACPI function.You can only change the content of Doze
Mode, Standby Mode, and Suspend Mode when the Power Management
is set to ‘User Define’.
Power Management: Use this to select your Power Management selection.
The default is User define.
Disabled: The system operates in NORMAL conditions (Non-GREEN), and
the Power Management function is disabled.
Max. saving: Maximum power savings. Inactivity period is 1 minute in each
mode.
Min. saving: Minimum power savings. Inactivity period is 1 hour in each mode.
ROM PCI/ISA BIOS (2A5LHPA9)
POWER MANAGEMENT SETUP
AWARD SOFTWARE, INC.
ACPI function : Enabled Primary INTR : ON
Power Management : User Define IRQ3 (COM 2) : Primary
PM Control by APM : Yes IRQ4 (COM 1) : Primary
Video off Method : V/H SYNC+Blank IRQ5 (LPT 2) : Primary
Video off After : Suspend IRQ6 (Floppy Disk) : Primary
MODEM Use IRQ : 3 IRQ7 (LPT 1) : Primary
Doze Mode : Disable IRQ8 (RTC Alarm) : Disabled
Suspend Mode : Disable IRQ9 (IRQ2 Redir) : Secondary
HDD Power Down : Disable IRQ10(Reserved) : Secondary
Soft-off by PWRBTN : Delay 4 Sec IRQ11(Reserved) : Secondary
PWRON After PW-Fail : Off IRQ12(PS/2 Mouse) : Primary
** PM Events ** IRQ13 (CoPro) : Disabled
VGA : OFF IRQ14 (HDD) : Primary
LPT & COM : LPT/COM IRQ15 (Rsv) : Disabled
HDD & FDD : NO
DMA/master : OFF
RTC Alarm Resume : Disabled
Modem Ring Resume : Disabled
Esc : Quit : Select Item
F1 : Help PU/PD/+/- : Modify
F5 : Old Values (Shift) F2 : Color
F7 : Load Setup Defaults
éé
éé
é
êê
êê
ê
èè
èè
è
çç
çç
ç