Specifications

InstallationKP6-LS
Page 3-5
Section 3-2
System Memory Configuration
Memory Layout
The KP6-LS supports (4) 168-pin DIMMs (Dual In-line Memory Module). The
DIMMs can be either EDO (Enhanced Data Out) or SDRAM (Synchronized
DRAM).
• DIMM SDRAM may be 83MHz (12ns), 100MHz (10ns) or
120MHz (8ns) bus speed.
• If you use both 50ns and 60ns memory you must configure
your BIOS to read 60ns.
• When using Synchronous DRAM we recommend using the
4 clock variety over the 2 clock.
• Fast Page Mode DRAM (FPM) is not supported by the LX
AGPset. Only EDO and SDRAM are supported.
Figure 2 and Table 1 show several possible memory configurations.
* SDRAM only supports 8, 16, 32, 64, 128MB DIMM modules.
Table 1
yromeMlatoT 1MMID 2MMID 3MMID 4MMID
BG1=
mumixaM
*MARDS/ODE
BM23,BM61,BM8
M652,BM821,BM46
1X
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
BM867=
mumixaM
*MARDS/ODE
BM23,BM61,BM8
M652,BM821,BM46
1X
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
enoN
BM215=
mumixaM
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
enoNenoN
BM652=
mumixaM
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
enoNenoNenoN