Specifications

BIOSEP-BX3
Page 4-15
Resume by Ring: This option is used to set the remote ring in feature. This option
is only available when Power Loss Recovery is Enabled.
The default is Enabled.
Enabled: The system can use remote ring-in to wake the system up.
Disabled: The system cannot use remote ring in to wake system up.
Power Loss Recovery: If the power to the system is cut off the system will turn
itself back on with no user intervention.
The default is Disabled.
Enabled: The system will power back on after a power interuption.
Disabled: The system will stay off after a power interuption.
Resume by Alarm: This option allows you to have the system turn on at a preset
time each day or on a certain day. This option is only available when Power Loss
Recovery is Enabled.
The default is Enabled.
Enabled: The system will turn on at the preset time.
Disabled: The system will not turn on until you turn it on.
Date (of month) Alarm: This is how you set the date that the system will turn on.
The default is 0.
0: Setting this to 0 will turn the system on everyday at the preset time.
1-31: Represents the day of the month that you need the system to turn on.
Time (hh:mm:ss) Alarm: This sets the time that you need the system to turn on.
The deault is 08:00:00.
**Reload Global Timer Events **
These options allow the user to reset the global power features timer if any of the
enabled events occur.
IRQ [3-7, 9-15], NMI: The default is Enable.
Primary IDE 0: The default is Disable.
Primary IDE 1: The default is Disable.
Secondary IDE 0: The default is Disable.
Secondary IDE 1: The default is Disable.
Floppy Disk: The default is Disable.
Serial Port: The default is Enable.
Parallel Port: The default is Disable.