Specifications

BIOSEP-BX3
Page 4-13
You can only change the content of Doze Mode, Standby Mode, and Suspend Mode
when the Power Management is set to ‘User Define’.
Power Management: Use this to select your Power Management selection.
The default is User define.
Disabled: The system operates in NORMAL conditions (Non-GREEN), and
the Power Management function is disabled.
Max. saving: Maximum power savings. Inactivity period is 1 minute in each
mode.
Min. saving: Minimum power savings. Inactivity period is 1 hour in each
mode.
User define: Allows user to define PM Timers parameters to control power
saving mode.
PM controlled APM: This option shows whether or not you want the Power
Management to be controlled the Advanced Power Management (APM).
The default is Yes.
Yes: APM controls your PM
No: APM does not control your PM
Video Off Method: This option allows you to select how the video will be disabled
by the power management.
The default is V/H Sync + Blank
V/H Sync + Blank: System turns off vertical and horizontal synchronization
ports and writes blanks to the video buffer.
DPMS: Select this option if your monitor supports the Display Power
Management Signaling (DPMS) standard of the Video Electronics Stan-
dards Association (VESA). Use the software supplied for your video sub-
system to select video power management values.
Blank Screen: System only writes blanks to the video buffer.
Video Off After: Tells you what time frame that the video will be disabled under
current power management settings.
The default is Standby.
Standby: Video powers off after time shown in standby mode setting.
Doze: Video powers off after time shown in doze mode setting.
Suspend: Video powers off after time shown in suspend mode setting.
N/A: Video power off not controlled by power management.