Specifications

Installation EP-BX3
Page 3-6
Table 1
*SDRAM only supports 8, 16, 32, 64, 128MB DIMM modules. 256MB only
supports Registered Synchronouts DRAM Memory Modules.
* EDO only supports Pentium
®
II Processor at 66MHz, not supports Deschutes
Processor at 100MHz.
DIMM Module Installation
Figure 3 displays the notch marks and what they should look like on your DIMM
memory module.
DIMMs have 168-pins and two notches that will match with the onboard DIMM
socket. DIMM modules are installed by placing the chip firmly into the socket at a
90 degree angle and pressing straight down (figure 6) until it fits tightly into the
DIMM socket (figure 7).
Figure 3
yromeMlatoT
1MMID
)0knaB(
2MMID
)1knaB(
3MMID
)2knaB(
BM867=
mumixaM
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
BM215=
mumixaM
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
enoN
BM652=
mumixaM
*MARDS/ODE
,BM23,BM61,BM8
BM652,BM821,BM46
1X
enoNenoN
CENTER KEY ZONE
(3.3 V DRAM)
LEFT KEY ZONE
(UNBUFFERED)