Specifications

InstallationEP-BX3

Page 3-3

Easy Installation Procedure

The following must be completed before powering on your new system:

3-1. Configure Jumpers to match your hardware

3-2. Install memory chips

3-3. Install Pentium II or Deschutes Processor

3-4. Device Connectors

Section 3-1

Configure Jumpers

We design this mainboard with the an ESDJ to make your install fast and easy.

The following will describe all of the ESDJ that you are required to set before moving

on to step 3-2.

Note: The ESDJ as depicted as shown (Figure 1) in their correct physical

orientation.

JP13

(Default)

Keyboard Power-ON function (refer the section 3-5)

JP13 = 1-2 - Enabled

= 2-3 - Disabled

J7 WOL (Wakup On Lan) Connector

Reserved for NIC (Network Interface Card) to

Wake the System.

JP1 = 1-2 - Run Mode (Default)

= 2-3 - Clear CM OS (momentarily)

JP1 CMOS Clear

J8 SB-LINK Header

Reserved for Creative SB-LINK (Sound Blaster

LINK ) with the Sound Blaster AWE64D PCI

Sound Card to Compatible DOS games and

M ultimedia applications.