Specifications

EP-USB66
Page 14
Software Installation
3. Partitioning Your Hard Disk
If the hard disk drive attached to the HPT366 host adapter has not been
partitioned and formatted yet, you need to partition it first. To partition the hard
disk drive attached to the HPT366 host adapter, follow tips below:
a. Click the Startup button.
b. Go to Administrative Tools (Common).
c. Run Disk Administrator.
d. Select disk number you would like to partition.
e. Select the menu Partition.
f. Decide the partition size create partition of the size.
g. Exit Disk Administrator.
h. Select the new created partition (logical disk drive) and format it.
4. Troubleshooting
The boot manager for Windows NT contains recovery logic to allow you to return
to the last known good configuration. If you have changed your host adapter
configuration and Windows NT no longer boots, follow these steps to recover:
a. Undo any hardware changes you have made to the computer since it was last
operational.
b. Reboot the computer. Watch the display carefully during booting up. If the
following message appears, press the Spacebar and follow the instructions on
the display screen to continue booting with the last known good configuration:
Press spacebar NOW to invoke the Last Known Good menu
c. Once your computer is operational again, check all of the hardware and software
configuration changes you want to make. Look specially for conflicts with parts
of the existing system configuration that are not being changed.
If Windows NT can boot but the driver has not been started (see Checking the
Installation), please check the followings:
a. Make sure the host adapter is properly installed, and the device is correctly
connected to the adapter. Double check that the cable between the adapter and
the devices is correctly attached. And also check the jumper setting on the drive
is correct.