Specifications

BIOSEP-BXBS
Page 4-23
controller.
Disabled: Disable the Onboard Winbond Chip’s floppy drive interface
controller.
Onboard Serial Port 1: This field allows the user to configure the 1st serial port.
The default is Auto.
AUTO: Enable Onboard Serial port 1 and address is Auto adjusted
COM1: Enable Onboard Serial port 1 and address is 3F8H/IRQ4.
COM2: Enable Onboard Serial port 1 and address is 2F8H/IRQ3.
COM3: Enable Onboard Serial port 1 and address is 3E8H/IRQ4.
COM4: Enable Onboard Serial port 1 and address is 2E8H/IRQ3.
Disabled: Disable Onboard Winbond CHIP’s Serial port 1.
Onboard Serial Port 2: This field allows the user to configure the 2nd serial port.
The default is Auto.
AUTO: Enable Onboard Serial port 2 and address is Auto adjusted
COM1: Enable Onboard Serial port 2 and address is 3F8H/IRQ4.
COM2: Enable Onboard Serial port 2 and address is 2F8H/IRQ3.
COM3: Enable Onboard Serial port 2 and address is 3E8H/IRQ4.
COM4: Enable Onboard Serial port 2 and address is 2E8H/IRQ3.
Disabled: Disable Onboard Winbond CHIP’s Serial port 2.
UART Mode Select: This field allows the user to configure what IR mode the 2nd
serial port should use.
The default is Normal.
Options: Normal, IrDA, and ASKIR.
RxD, RxD Active: This field configures the receive and transmit signals generated
from the IR port.
The default is Hi Lo (when UART Mode Select is not set to Normal).
Options: Hi Hi, Hi Lo, Lo Hi, and Lo Lo.
IR Transmitting delay:
The default is Enabled (when UART Mode Select is not set to Normal).
Options: Enabled and Disabled.
Onboard Parallel port: This field allows the user to configure the LPT port.
The default is 378H / IRQ7.