Specifications

BIOS EP-BXBS
Page 4-22
USB Keyboard Support: This controls the activation status of an optional USB
keyboard that may be attached.
The default is disabled.
Enabled: Enable USB keyboard support.
Disabled: Disable USB keyboard support.
Init Display First: If two video cards are used (1 AGP and 1 PCI) this specifies
which one will be the primary display adapter.
The default is PCI Slot.
PCI Slots: PCI video card will be primary adapter.
AGP: AGP video card will be primary adapter.
Power On Method: This option allows user to select one of the various methods to
power on the system. (See section 3-5 for additional information about KBPO).
The default is Hot Key.
Hot Key: User can press a combination of the “Control Key” (Ctrl) and a
“Function Key” to power on the system. (See “Hot Key Power On” option
below).
Anykey: Press any key to power on the system.
Button only: This power on method is controlled by J3 (pw-on). Use the
power switch to power on the system.
Password: User can power on the system by a 1 ~ 5 character password. If
the password is forgot go back to this option in the BIOS and enter a new
password.
Hot Key Power On: Use this option with the above “Power On Method” to set a
combination of keys that can be used to power the system on.
The default is Ctrl-F1.
Options: Ctrl-F1, Ctrl-F2, Ctrl-F3, Ctrl-F4, Ctrl-F5, Ctrl-F6, Ctrl-F7, Ctrl-
F8, Ctrl-F9, Ctrl-F10, Ctrl-F11, and Ctrl-F12.
KBC input clock: This sets the keyboard clock value.
The default is 12 MHz.
Options: 6, 8, 12, 16 are the available choices.
Onboard FDC Controller: This controls the state of the onboard floppy controller.
The default value is Enabled.
Enabled: Enable the Onboard Winbond Chips’s floppy drive interface