Specifications

BIOSEP-BXBS
Page 4-15
MODEM Use IRQ: Name the interrupt request (IRQ) line assigned to the modem
(if any) on your system. Activity of the selected IRQ always awakens the system.
Default is IRQ 3.
N/A: No IRQ is used. 3: IRQ 3
4: IRQ 4 5: IRQ 5
7: IRQ 7 9: IRQ 9
10: IRQ 10 11: IRQ 11
The EP-BXBS supports HDD Power Down, Doze and Standby power saving
functions when using the Intel Pentium II Processor.
The default is Disabled
Doze Mode: The “Doze” mode timer starts to count when no “PM events” have
occurred.
Standby Mode: When the standby mode timer times-out, it will enter the standby
mode and retain CPU at a slow working speed. The screen will be blanked out.
Suspend Mode: This function works only when the Pentium II Processor is
installed. The timer starts to count when “System Standby” mode timer is timed out
and no “PM Events” are occurring. Valid range is from 1 minute up to 1 hour.
HDD Power Down: HDD Standby timer can be set from 1 to 15 minute(s).
Throttle Duty Cycle: Sets how much performance will be lost during a power
management mode. Default is 62.5%.
PCI/VGA Act-Monitor: Use this option if your monitor has advanced power
saving features.
The default is Disabled
Enabled: Your monitor’s power features will be included in power
management.
Disabled: Your monitor’s power features will not be included in power
management.
Soft-Off by PWR-BTTN: Use this to select how the power switch will function.
The default is Instant Off.
Instant Off: Turns off the power instantly when the power switch is pressed.
4 Second Delay: Turns off after a 4 second delay. If the power switch is
pressed and held for less than 4 seconds the system will go into Suspend
Mode. Press again to take system out of Suspend Mode.