Specifications

Installation EP-BXBS
Page 3-10
Section 3-4
Device Connectors
Please install the motherboard into the chassis.
Now that your motherboard is installed you are ready to connect all your connections
(figure 12).
USB 1
(Top)
USB 0
(Bottom)
PS/2 Mouse
(Top)
PS/2 Keyboard
(Bottom)
Parallel Port
(Top)
Com1 Com2
(Bottom Left) (Bottom
Right)
FDD1:Floppy controller
IDE1:Primary IDE
IDE2:Secondary IDE
J1: SB-Link
J2/J3:Chassis panel connector
(Keylock, Speaker, Reset, Turbo, Sleep, and HDD LED)
J4: CPU 1 fan power (plug-in for compatible FANs which allow monitoring)
J5: CPU 2 fan power (plug-in for compatible FANs which allow monitoring)
J6: Chassis fan power (plug-in for compatible FANs which allow monitoring)
J7: Wake-On-Lan (WOL)
PW1: ATX power connector (20-pin power connector)
SCJ1:68-pin wide SCSI for legacy single-ended (SE) SCSI devices
SCJ2:50-pin narrow SCSI for legacy single-ended (SE) SCSI devices
SCJ3:68-pin wide SCSI for Ultra-2 LVD SCSI devices
Figure 12