Specifications

FeaturesEP-BXBS
Page 2-1
Section 2
FEATURES
EP-BXBS Features:
• EP-BXBS is based on the Dual Pentium
®
II Processor operating at 233 ~ 333
MHz (66MHz) or 300-450 MHz (100MHz) on Slot 1. The board is configured
by an Easy-Setting-Single-Jumper (E.S.S.J.) to match your CPU clock speed.
• Designed with Intel’s 82443 BX AGPset.
• Supports up to 1 Gigabyte of SDRAM (minimum of 8 MB) on board, You can
use 168-pin DIMM x 4. It will automatically detect Extended Data Output
(EDO) DRAM or Synchronous DRAM memory (SDRAM) (please see
Section 3-2).
• EP-BXBS will support Error Checking and Correcting (ECC) when using
parity DRAM memory modules. This will detect multiple bit errors and correct
1-bit memory errors.
• Supports (2) 16 bit ISA slots, (4) 32 bit PCI slots, (1) AGP slot and provides
(2) independent high performance PCI IDE interfaces capable of supporting
PIO Mode 3/4 and Ultra DMA 33 devices. The EP-BXBS supports (4) PCI
Bus Master slots and a jumperless PCI INT# control scheme which reduces
configuration confusion when plugging in PCI card(s).
• Supports ATAPI (e.g. CD-ROM) devices on both Primary and Secondary IDE
interfaces.
• Designed with Adaptec AIC-7890 Ultra-2 Wide SCSI for LVD (80 Mbytes/
sec) devices and Adaptec AIC-3860 for legacy single-ended SCSI devices.
(please see Section 3-6).
• Designed with Winbond W83977 Multi I/O: (1) floppy port, (1) parallel port
(EPP, ECP), and (2) serial ports (16550 Fast UART), (1) IrDA.
Note: Japanese “Floppy 3 mode” is also supported
• Includes a PS/2 mouse connector.
• Allows use of a PS/2 or AT keyboard (with optional adapter).