Technical information

Hardware Design 2-9
DIMM Module Installation
Figure 2-2 displays the notch marks and what they should look like on your
DIMM memory module.
DIMMs have 168-pins and two notches that will match with the onboard
DIMM socket. DIMM modules are installed by placing the chip firmly into
the socket at a 90 degree angle and pressing straight down (figure 2-3) until
it fits tightly into the DIMM socket (figure 2-4).
CENTER KEY ZONE
(3.3 V DRAM)
LEFT KEY ZONE
(UNBUFFERED)
Figure 2-2
Figure 2-3
DIMM Module clip before installation
Figure 2-4
DIMM Module clip after installation
To remove the DIMM module simply press down both of the white clips on
either side and the module will be released from the socket.