Specifications

BIOSEP-MVP3G-M/2/5
Page 4-15
Onchip IDE First Channel: The default value is Enabled.
Enabled: Enables Onboard IDE primary port.
Disabled: Disables Onboard IDE primary port.
Onchip IDE Second Channel: The default is Enabled.
Enabled: Enables Onboard IDE secondary port.
Disabled: Disables Onboard IDE secondary port.
IDE Prefetch Mode: Enable prefetching for IDE drive interfaces that support its
faster drive accesses. If uou are getting disk drive errors, change the setting to
omit the drive interface where the errors occur. Depending on the configuration of
your IDE subsystem, this field may not appear, and it does not appear when the
Internal PCI/IDE field, above, is Disabled.
4-6 INTEGRATED PERIPHERALS4-6 INTEGRATED PERIPHERALS
4-6 INTEGRATED PERIPHERALS4-6 INTEGRATED PERIPHERALS
4-6 INTEGRATED PERIPHERALS
ROM PCI/ISA BIOS (2A5LEPAE)
INTEGRATER PERIPHERALS
WARD SOFTWARE, INC.
OnChip IDE First Channel : Enabled Onboard Parallel Port : 378/IRQ7
OnChip IDE Second Channel : Enabled Onboard Parallel Mode : ECP / EPP
IDE Prefetch Mode : Enabled ECP Mode Use DMA : 3
IDE HDD Block Mode : Enabled Parallel Port EPP Type : EPP1.9
IDE primary Master PIO : Auto OnChip USB : Enabled
IDE Primary Slave PIO : Auto USB Keyboard Support : Disabled
IDE Secondary Master PIO : Auto
IDE Secondary Slave PIO : Auto
IDE Primary Master UDMA : Auto
IDE Primary Slave UDMA : Auto
IDE Secondary Master UDMA : Auto
IDE Secondary Slave UDMA : Auto
IDEInit Display First : PCI Slot
Onboard FDD Controller : Enabled
Onboard Serial Port 1 : 3F8/IRQ4
Onboard Serial Port 2 : 2F8/IRQ3
UART 2 Mode : Standard
IR Function Duplex : Half
RxD, TxD Active : Hi, Hi
ESC : Quit : Select Item
F1 : Help PU/PD/+/- : Modify
F5 : No Change (Shift) F2 : Color
F7 : Load Setup Defaults
Note: If you do not use the Onboard IDE connector, then you will need to
set Onboard Primary PCI IDE: Disabled and Onboard Secondary
PCI IDE: Disabled
Note: The Onboard PCI IDE cable should be equal to or less than 18 inches
(45 cm.).