Specifications

InstallationEP-3WXM/2/4

Page 3-3

Easy Installation Procedure

The following must be completed before powering on your new system:

3-1. Configure Jumpers to match your hardware

3-2. System Memory Configuration

3-3. Device Connectors

3-4. External Modem Ring-in Power ON and Keyboard Power ON

Functions (KBPO)

Section 3-1

Configure Jumpers

The EP-3WXM/2/4 designs all motherboards with the fewest jumpers to make

your installation fast and easy.

The following will describe all of the jumpers that you are required to set before

moving on to step 3-2.

Note: The jumpers as depicted as shown (Figure 1) in their correct

physical orientation.

JP1 CMOS Clear

JP1 = 1-2 Normal (Default)

= 2-3 Clear CMOS

CPU Speed SelectionJP3

100MHz

Rsd

66MHz

AUTO

(Default)

* Note: If CPU is S-Spec processor, than ignore the

CPU ratio setting, otherwise the CPU ratio

setting in BIOS (Frequency/Voltage Control).

Rsd: Reserved

JP13

Keyboard Power-ON Function

JP13= 1-2 Enabled

= 2-3 Disabled (Default)