Specifications

BIOS
EP-3VCA
Page 4-13
Soft-Off by PWRBTN: Use this to select your soft-off function.
The default is Delay 4 sec.
Instant Off: Turns off the system instantly.
Delay 4 Second : Turns off the system after a 4 second delay. If momentary
press of button, the system will go into Suspend Mode. Press
the power botton again to take system out of Suspend Mode.
HDD Power Down: HDD Standby timer can be set from 1 to 15 minute(s).
Doze Mode: The Doze mode timer starts to count when no PM events have
occurred.
Suspend Mode: This function works only when the Pentium II Processor is
installed. The timer starts to count when System Standby mode timer is timed
out and no PM Events are occurring. Valid range is from 1 minute up to 1 hour.
VGA: When set to On (default), any event occurring at a VGA port will awaken a
system which has been powered down.
LPT & COM: When set to On (default), any event occurring at a COM(serial)/
LPT (printer) port will awaken a system which has been powered down.
HDD & FDD: When set to On (default), any event occurring at a hard or floppy
drive port will awaken a system which has been powered down.
PCI Master: When set to On (default), any event occurring to the DMA control-
ler will awaken a system which has been powered down.
Modem Ring Resume: When set to Enabled, any event occurring to the Modem
Ring will awaken a system which has been powered down.
RTC Alarm Resume: When set to Enable rtc alarm resume, you could set the
date (of month) and timer (hh:mm:ss), any event occurring at will awaken a
system which has been powered down.
Primary INTR: When set to On (default), any event occurring at will awaken a
system which has been powered down.