User`s manual

Appendix
D-14
c) DST This defines the destination location for the operation:
Mode Meaning
COPY/
LOAD Destination drive (e.g, 2 for drive two)
DUMP
Disk image filename or device,(e.g, g:\images\system2.img)
PCOPY/
PLOAD Destination partition,(e.g, 2:2 indicates the second
partition on drive two).
PDUMP Partition image filename (e.g, g:\images\part1.img).
d) SZEy Partition size to be transferred.
Available Options:
F Resizes the first partition to maximum size allowed based
on file system type.
L Resizes the last partition to maximum size allowed based on
file system type.
n=xxxxM - indicates that the n?h destination partition is set to have a
size of xxxx Mb. (e.g, SZE2=800M indicates partition two
is to have 800 mb.) n=mmP indicates the destination
partition is set to have a size of mm percent of the target
disk.
n=F - indicates the destination partition is remaining fixed size.
n=V - Indicates that the partition will be resized according to the
following rules:
Rule 1 - If the destination disk is larger than the original
source disk, then the partition(s) will be expanded to have
the maximum amount of space subject to the free space
available and the partition type (e.g, FAT16 partitions will
have a maximum size of 2048Mb.)
Rule 2 - If the destination disk is smaller than the original
source disk, (but still large enough to accommodate the
data from the source disk), the free space left over after the
data space has been satisfied will be distributed between the