User`s manual

BIOS
Page 4-21
PCI/VGA Palette Snoop
This item is designed to overcome problems that can be caused by some nonstandard
VGA cards. This board includes a built-in VGA system that does not require palette
snooping so you must leave this item disabled.
Options: Enabled, Disabled.
PCI Latency Timer (CLK)
The latency timer defines the minimum amount of time, in PCI clock cycles, that
the bus master can retain the ownership of the bus.
Options: 0-255.
AGP SLOT INT Assignment
This setting enables the user to specify what IRQ will be assigned to the AGP
devices in the AGP slot.
Options available: Auto, 3, 4, 5, 7,9 ,10, 11, 12, 14 & 15. The default is Auto.
AC97 INT Assignment
This setting enable the user to specify what IRQ will be assigned to the AC97
device .
Options available: Auto, 3, 4, 5, 7,9 ,10, 11, 12, 14 & 15. The default is Auto.
HighPoint INT Assignment
This setting enable the user to specify what IRQ will be assigned to the HighPoint
device .
Options available: Auto, 3, 4, 5, 7,9 ,10, 11, 12, 14 & 15. The default is Auto.
PCI Slot 1 ~ Slot 5 INT Assignment
These settings enables the user to specify what IRQ will be assigned to PCI
devices in the chosen slot.
Options available: Auto, 3, 4, 5, 7,9 ,10, 11, 12, 14 & 15. The defaults are Auto.