User`s manual

S-ATA RAID Configuration
Page 5-7
4. Insert a blank floppy into the A:drive
5. Click on the required driver to begin copy into the floppy


 Step 3: Install O/S into RAID disk
Continue to install Windows XP/2000/NT4.0 as normal. When requested by
Windows Setup for RAID driver, insert the floppy created earlier in Step 2.


 Step 4: Install Software utility for Windows
After the O/S has been installed, you may install the RAID driver and software. The
RAID software is a Windows-based utility with graphical user interface that
provides an easy operating tool to configure and manage RAID arrays.
1)Insert the bundled CD into the CD-ROM drive.
2) When the main menu appears, click on the SATA RAID driver corresponding
to the SATA controller you have configured in Step 1. See driver installation in
section 6 for more details.
Note: For information on using the software utility, refer to the user guide in
the bundled CD.