User's Manual
Table Of Contents
- Chapter One Introduction to Bluetooth
- Chapter Two Installation
- Chapter Three Basic Operations
- Chapter Four Client Appliance
- Chapter Five Local Services
- Chapter Six Configuration Panel
- _
- Accessibility Tab
- Discovery Tab
- General Configuration Settings
- Hardware Configuration
- Plug in Dongle
- Information Exchange Configuration Settings
- Local Services Tab
- Notifications Tab
- Chapter Seven Security
- Chapter Eight Troubleshooting
- FCC Notices
EpoX BlueTooth Dongle User’s Guide
7
Chapter Two
Installation
b) From the Windows taskbar, click Start
followed by Settings followed by Control
Panel.
c) Double-click Add/Remove Programs.
d) On the Add/Remove Programs window,
select the EPoX Bluetooth Software entry.
Scroll down if necessary.
Installing Bluetooth for
Windows (BTW)
e) Click the Change/Remove button
(Windows 2000). The Install Shield
Wizard is started.
SYSTEM REQUIREMENTS
Bluetooth for Windows (BTW) runs
under Microsoft® Windows® 2000,
Windows 98 Second Edition (SE), and
Windows Millennium Edition (“Me”).
f) Click OK on the Confirm File Deletion
window to remove the EPoX Bluetooth
Software and all of its components.
g) When prompted, click Restart and then
click the Finish button.
UNINSTALL PREVIOUS
VERSION OF BTW
Any previous version of the BTW
software must be uninstalled before
installing an upgraded version.
There are two ways to remove BTW:
1. The Install Shield® Wizard
automatically uninstalls the previous
version when a new version is installed.
2. Manually uninstall BTW by
completing these steps:
a) Close any open applications.