User's Manual
Table Of Contents
- Chapter One Introduction to Bluetooth
- Chapter Two Installation
- Chapter Three Basic Operations
- Chapter Four Client Appliance
- Chapter Five Local Services
- Chapter Six Configuration Panel
- _
- Accessibility Tab
- Discovery Tab
- General Configuration Settings
- Hardware Configuration
- Plug in Dongle
- Information Exchange Configuration Settings
- Local Services Tab
- Notifications Tab
- Chapter Seven Security
- Chapter Eight Troubleshooting
- FCC Notices
EpoX BlueTooth Dongle User’s Guide
22
Click YES in the confirmation dialog box
to enable Internet connection sharing
Network Access Setup for
Windows 98SE & Windows
Me
Internet Protocol routing software is
required on Windows 98SE and Windows
Me servers; a downloadable trial version
of Win Route Lite is available on the Tiny
Software, Inc.
Configure the server:
From the Windows Control Panel,
double-click the Network icon.
On the Configuration tab, select
TCP/IP-> Bluetooth LAN Access Server
Driver (scroll down if necessary).
Click Properties and select the IP
Address tab.
Select Specify an IP address
Enter an IP Address (suggested value
192.168.1.1).
Enter a Subnet Mask (suggested value
255.255.255.0).
Click OK twice to close the dialog
boxes.
Click YES to restart the computer.
Configure the routing software:
In the Windows system tray, right-click
the Win Route icon and select
Administration
On the Settings tab, select and network
adapter
From the Network adapter drop-down
list, choose any adapter other than the
EPoX adapter, and then click the
Settings button.
On the DHCP tab, in the Adapter
drop-down list, select the EPoX
Bluetooth Windows 9x Adapter.
Select Enable DHCP Server.
Fill in the client IP address range fields:
From 10
To 40
Click the OK button and then minimize
(do not close) the Win Route
administration configuration panel.
Bluetooth Serial Port
The Bluetooth Serial Port service allows
two Bluetooth devices to establish a
wireless connection through virtual