User's Manual
Table Of Contents
- Chapter One Introduction to Bluetooth
- Chapter Two Installation
- Chapter Three Basic Operations
- Chapter Four Client Appliance
- Chapter Five Local Services
- Chapter Six Configuration Panel
- _
- Accessibility Tab
- Discovery Tab
- General Configuration Settings
- Hardware Configuration
- Plug in Dongle
- Information Exchange Configuration Settings
- Local Services Tab
- Notifications Tab
- Chapter Seven Security
- Chapter Eight Troubleshooting
- FCC Notices
EpoX BlueTooth Dongle User’s Guide
18
Click the Next button.
If the service that was selected in the
Select Bluetooth Service dialog box is
not offered by the device that was
selected in the elect a device that
provides the service drop-down menu,
then the Select Bluetooth Service dialog
box appears with a list of services that
are offered by the selected device:
Select a different service from the
Select Bluetooth Service dialog box
and click the OK button to proceed or
Click the Cancel button to close the
Select Bluetooth Service dialog box
and return to the previous screen, from
which you can select a different
device.
If more than one service of the type
selected in the Select a Service
drop-down menu (above) exists on the
selected device, for example, multiple
Bluetooth Serial Ports, and then the
Select Bluetooth Service dialog box
appears. Select the specific service to be
used and then click the OK button to
close the Select Bluetooth Service dialog
box.
If only one service of the type selected
in the Select a Service drop-down menu
(above) exists on the selected device, the
next Connection Wizard screen appears.
If "Require secure encrypted
connection" was selected, above, a
security screen appears.
To establish a paired relationship with
the remote device while using this
wizard, enter your Personal
Identification Number in the PIN
Code field and then click the Next
button.
To establish the paired relationship
with the remote device the first time
this connection is used, leave the PIN
Code field blank and click the Next
button.
On the last Connection Wizard screen:
The top of the screen provides basic
information about the new connection
he name of the device that will
provide the service and the name of
the service that will be provided. If
this information is NOT correct, click
the Back button to return to the
previous screen and from that screen
select the correct service and device.
In the connection Name: field, enter a
descriptive name for the connection,
for example, T Serial Connection to
Joe Desktop.
Optional: select make
<selected_device> the default
Bluetooth device for <service_name>