User's Manual
Table Of Contents
- Chapter One Introduction to Bluetooth
- Chapter Two Installation
- Chapter Three Basic Operations
- Chapter Four Client Appliance
- Chapter Five Local Services
- Chapter Six Configuration Panel
- _
- Accessibility Tab
- Discovery Tab
- General Configuration Settings
- Hardware Configuration
- Plug in Dongle
- Information Exchange Configuration Settings
- Local Services Tab
- Notifications Tab
- Chapter Seven Security
- Chapter Eight Troubleshooting
- FCC Notices
EpoX BlueTooth Dongle User’s Guide
16
All Bluetooth servers do not necessarily
provide all of these services. For example,
network gateways only provide access to
the Local Area Network (the Network
Access service).
Bluetooth Connection
Status
Information provided is
Status: Connected or Disconnected.
Device Name: the name of the device to
which this computer is connected.
The Bluetooth Connection Status dialog
box displays information about the state
of a connection and provides a means to
disconnect an active connection.
Duration: the length of time that this
connection has been established,
displayed in hours, minutes and
seconds. Depending on the service, the
connection may time out (automatically
disconnect) after a specific period of
inactivity.
Display the Connection Status dialog
box
In My Bluetooth Places, from the
Folders pane, select (highlight) a device.
In the right pane of My Bluetooth Places,
right-click a service name and select
Status from the pop-up menu.
Activity: the number of bytes sent and
received over the connection.
Signal Strength: a variable scale that
ranges from Too Weak through Good to
Too Strong.
To change the power transmission level