Installation Guide

- 7 -
The connector is separately matched.
If the angle valve interface does not match
the water pipe,
you can connect a 1/2 to 7/8 adapter
15.Apply some glass glue to fix the
toilet and insulate the outside dirt from
entering.(The glass adhesive in the
picture needs to be purchased by oneself.)
16.Finally connecting the flexible tube
to the inlet angle valve
Attention: The above installation steps are universal for all models of toilets and are only
for your reference during installation.
If you find that the details in the pictures do not match the actual product, please ignore them!
14.Install the screws on the toilet seat
and put on the fixing