Installation Guide

- 6 -
1.The confirmation of the installation
environmentThe measurement
distance is 300mm or greater
The confirmation of the installation
environment
2.Put the flange ring into the drain
outlet and mark the screws positions
6.Install two long screws as
below picture
8.Take off the whole toilet seat and
unscrew the flexible tube and black wire
9.Turn over the toilet bowl and install
the flange ring as below picture
10.Apply some glass glue on the
bottom of the toiletThe glass
adhesive in the picture needs to be
purchased by oneself.
11.Move the toilet to the location where
it will be installed
12.Make sure two holes in the bottom
of the toilet align with the two long
screws in the flange ring,then install it
13.Put the toilet seat in the toilet
and reconnecting the flexible tube
and black wire
3.Take off the flange ring and
drill four holes for screws
4.Put the screws into the holes
5.Put the flange ring into the drain
outlet and install it
The confirmation of the installation
environment
7.Unscrew the screws on the toilet seat