Installation Guide

- 4 -
Daily cleaning and maintenance
Note: During cleaning and maintenance, please be sure
to unplug the power switch and power off
Description of other functions
Flushing by foot sensor
Close to the foot sensor, turn on the scour function (manual clamshell)
Open cover and seat by foot sensor
Close to the foot sensor, automatically open/close cover
and seat (automatic flip cover)
Radar automatic clamshell function
Close to the toilet, automatically open the cover, automatically close the
cover after leaving and flush automatically (automatic flip cover)
Smart toilet cleaning and maintenance methods
Please wipe it with a soft cloth dampened with water
- If the dirt is not removed in time, it will become difficult to clean,
please wipe with water sometimes.
- Static electricity will absorb dust, resulting in the product black, dirty,
water wipe can prevent the generation of static electricity.
- The ceramic body can be removed from the toilet seat to facilitate cleaning between
the toilet seat and the ceramic body.
Cleaning and maintenance of spray head
If there is dirt in the nozzle. Please clean it with a small
brush such as a toothbrush.
- Do not stretch and bend the spray head.
Clean the dust on the power plug regularly
When cleaning, remove the power plug and wipe with a dry
cleaning cloth.
- Poor insulation may cause a fire.
Must obey
Unplug the power supply
before maintenance
Common fault diagnosis
Note: If similar fault is found, please read the following
solution or contact after sales
Fault phenomenon
Fault analysis Fault handling
Product unavailable
Check to see if the power/socket
is loose
Please check the circuit
Whether there is leakage
(the display light of leakage
protection plug is not on)
Remove the power plug from the socket and replug it
later.Press the reset switch of the leakage protection
plug. If the elbow still cannot be operated, please
unplug the power plug and entrust the repair.
No water with spray
Check if water is cut off
Pending resumption of water supply
Check that the Angle valve is closed Open the Angle valve
Check if the inlet filter is blocked
Clean or replace the filter
Check the inlet pipe for bends
Exclude the intake bend
Check whether the cleaning pressure
is at the lowest level
Refer to the instruction manual for regulating the
water pressure
Check if the inlet filter is blocked
Clean or replace the filter
Abnormal operation
Unplug the plug for one minute and then switch it
back on
Check that the water temperature
is set low
Adjust the water temperature according to the
instructions
Whether the hot and cold massage
function is on
Turn off the hot and cold massage function according
to the instructions
Solenoid valve failure
Please get professional maintenance technicians
Cleaning insufficient
rigidity
Spray water disorderly
water temperature
is not enough
The washer
often drips water