User manual

Using additional functions

RS 2000 | 21

Using additional functions

The following additional functions are not required for normal use,

but allow you to extend the potential use of the wireless headphone

system.

Pairing the stethoset receiver with the transmitter

The stethoset receiver and the transmitter of your wireless head-

phone system are factory pre-paired. The following steps are only

necessary if you want to reestablish the pairing or pair additional

stethoset receivers with the transmitter.

You can simultaneously connect up to 2 paired stethoset receivers

to your transmitter.

1 Make sure that there is only one transmitter within the transmis-

sion range.

2 Place the stethoset receiver as close as possible to the transmit-

ter.

3 Switch the stethoset receiver on by pulling the ear bows apart.

4 Simultaneously press and hold the volume buttons +/- for at

least 5 seconds until the

Receiver status

LED flashes green rap-

idly.

5 Then release the volume buttons +/-.

Once paring is completed, the

Receiver status

LED and the

Trans-

mitter status

LED light up green. The audio transmission starts.

3 4