User guide

Physical Attributes
10
Lecture Recorder x2 User Guide
above.
11
RJ45 Ethernet
Primary 10/100 Base-T RJ-45 Ethernet network port to
connect the Lecture Recorder x2 to an Ethernet
network. The Lecture Recorder x2’s Ethernet port is
auto-sensing.
Power over Ethernet is used to power the Lecture
Recorder x2. If the intended network connection does
not provide power over Ethernet, use the Power over
Ethernet Injector and this port in order to power the
device.
3.2 Cables, Connectors and Adapters
The Lecture Recorder x2 can be connected to a number of different types of
equipment using a variety of cables, and adapters. This section describes a subset of
connectors, cables and adapters that are known to be compatible with the Lecture
Recorder x2.
3.2.1 3.5 mm Mini-jack
A 3.5mm mini jack connector is used to carry audio signals. It can be connected to
Lecture Recorder x2 to either its Audio In port or its Audio Out port.
Figure 3 3.5mm Mini-jack