User guide

System Administration
100
Lecture Recorder x2 User Guide
Figure 65 Maintenance Options
12.6.1 Restoring the Lecture Recorder x2 Default Factory Configuration
Select Restore beside Restore Factory Configuration to reset the stream and frame
grabber settings back to the default factory configuration. The default factory
configuration is the configuration that the Lecture Recorder x2 had when it was
received from Epiphan. It can be useful to return the Lecture Recorder x2 to this
configuration if a number of configuration changes have been made that need to be
reversed.
Note that restoring default factory configuration also restores default network
configuration (DHCP settings are enabled by default).
Pressing the Reset button on the Lecture Recorder x2 will also perform a reset to the
default factory configuration. See the section, System Hardware Features , for
information on the location of the reset button and the proper steps that need to be
followed to perform a hardware based factory reset.
12.6.2 Rebooting or Restarting Lecture Recorder x2
Many Lecture Recorder x2 configuration changes require you to reboot the Lecture
Recorder x2 in order to have these changes come into effect, the following outlines
the steps to reboot the Lecture Recorder x2.