Specifications

Lecture Recorder x2 User Guide 1-3 Configure Network Settings

Label Description/Options

Default Gateway The network node that serves as an access point to the rest of the network. This value

cannot be blank. Specify the system’s IP address if you don’t have a default gateway on

your network.

DNS Server The domain name system server (DNS server) translates human-readable hostnames

into corresponding IP addresses. Specify the system’s IP address if you don’t have a

DNSserver on your network.

MTU Size The maximum transmission unit (MTU) specifies the maximum packet size for transfer

on the network. The default value is 1500, which is the largest value allowed by

Ethernet at the network layer. It’s best if all nodes in your network use the same value,

so only change this value if you know other nodes use a different value.



Configure DHCP

Occasionally, such as when moving your system to a new network, your Lecture Recorder x2 must switch from

static IP address allocation to dynamic allocation via DHCP. You can accomplish this three ways:

l Use the factory reset button to clear all your settings. See Restoring Factory Configuration.

l Load a configuration file that uses DHCP networking. See Load a saved device configuration.

l Changing the network settings. See the procedure below.

To configure use of DHCP for networking:

1. Connect to the admin interface using your preferred connection mechanism. See Connect to the Admin

Interface.

2. Login as admin.

3. Select the Network link in the Configuration menu; the network configuration page opens.

4. Select the radio button use DHCP, if not already selected.

5. Change the MTU Size value only if needed. See the table below for information on maximum

transmission unit (MTU) values.

6. Click Apply to save the changes; the changes are saved and a message appears asking you to reboot.