User Manual

Pearl-2 User Guide One Touch streaming and recording control
In the example above, One Touch control has been activated and all six out of the six total
channels and/or recorders are recording successfully. There is no streaming activity because
there are no channels configured for One Touch streaming.
An error icon displays if there's a problem with the streaming and/or recording settings for one or more of the
channels and recorders. All other channels and recorders that are working correctly continue to stream and
record normally.
In this example, after pressing Start, both recorders/channels are recording properly but the
one channel configured for streaming is not streaming correctly.
To troubleshoot, investigate each channel's streaming configuration page using the Admin panel
and identify which channel isn't streaming. Then correct any streaming configuration errors.
See Specify channels for One Touch streaming and Specify channels and recorders for One Touch recording
for more information about configuring channels and recorders for One Touch control.
Customize the One Touch control display
You can use the Admin panel to customize how One Touch Control is displayed on the touch screen of Pearl-2:
l Default: The One Touch control screen is accessed by tapping the One Touch control icon at the
bottom of the touch screen.
l Start Screen: The One Touch control screen displays automatically on the touch screen when you
power on Pearl-2. Operators can still navigate to other screens from the One Touch control screen.
l Locked: The One Touch control screen is the only screen that displays on the touch screen of Pearl-2.
Operators cannot navigate to other screens from the One Touch control screen.
To configure how the One Touch control screen displays on the touch screen:
49