User Manual

Pearl-2 User Guide Configure AFU to RSync server parameters
Table 62 RSync Automatic FileUpload ConfigurationParameters
Name Description
Server
address
The IP address (or fully qualified domain name) of the RSync server.
Server module The name of the shared folder on the RSync server.
Login Username for the RSync server.
Password Password for the RSync user.
Checksum
Select to enable checksum checking during file transfer. This increases the time taken to
transfer, but also increases reliability of the transfer.
Prerequisites
l Channels and recorders are already added for AFU, see Choose files to include in AFU
l AFU is enabled and the parameters configured, see Enable AFU and set parameters.
To configure upload using RSync:
1. From the Automatic File Upload configuration page, select RSync Client as the protocol transfer type.
2. Specify the target Server address. If your system is configured with DHCP or has a valid DNS
configuration (see Configure DHCP), you can use the server’s fully qualified domain name instead of
the IP address.
3. Specify the Server module. This is the name of the shared folder on the server. If needed, request this
value from your network administrator.
382