User Manual
Pearl-2 User Guide Configure AFU to RSync server parameters
Prerequisites
l Channels and recorders are already added for AFU, see Choose files to include in AFU
l AFU is enabled and the parameters configured, see Enable AFU and set parameters.
To set the FTP server parameters for AFU:
1. From the Automatic File Upload configuration page, select FTP Client as the protocol transfer type.
2. Specify the target Server address. If your system is configured with DHCP or has a valid DNS
configuration (see Configure DHCP), you can use the server’s fully qualified domain name instead of
the IP address.
3. Specify the Server Port used for the target FTP server. The standard port is 21.
4. Enter the FTP account username in the Login field.
5. Enter the FTP account password in the Password field. The characters are masked with dots.
6. Select Use temp file to name files with a temporary filename extension (.part) on the server until
upload is complete.
7. Click Apply.
Configure AFU to RSync server parameters
You can automatically upload recordings to an RSync server when you select RSync as the AFU protocol
transfer type using the Admin panel.
The following table describes the parameters to configure for AFU to an RSyncserver.
381