User Manual

Pearl-2 User Guide Stream to Original Livestream
After clicking either Transcoder or Publish Start buttons, there can be a short delay before the
stream is established.
See Start and stop streaming to a CDN for instructions to start streaming from the touch screen or see
Control streaming and recording for instructions to use Epiphan Live.
Stop streaming to the Wowza Streaming Cloud
When you are done streaming, be sure to stop the Wowza Transcoder by either returning to the channel's
streaming page and pressing the Stop Transcoder button, or by logging into the Wowza Cloud and stopping
the stream. Charges from Wowza continue until the Wowza Cloud stream is stopped in one of these two
ways.
Stopping the stream by using the touch screen , pressing Stop or by the Epiphan Live Publish
button does not stop the charges applied by Wowza.
Stream to Original Livestream
To set up streaming via the OriginalLivestream service, you first need to sign in to your Original Livestream
account and create a new stream.
To setupstreaming to the original Livestream:
1. Login to the Admin panel as admin, see Connect to the Admin panel.
3. From the Channels menu, select a channel and click Encoding. The channel's Encoding page opens.
4. Set the Codec to H.264, the Resolution to 640x480, the Frame rate to 30 fps, the Bitrate to 4 kbps,
and the audio to 64 kbps AAC.
Configuring audio is optional. Supported formats are limited to MP3 and AAC. Due to RTMP
restrictions, MP3 48 kHz is not supported.
5. Click Apply.
6. Click Streaming for the channel. The Streaming configuration page opens.
321