User Manual

Configuring SDI2USB 3.0 from the Control Panel
a) Click the
Default Configuration
button to make changes to the
default configuration; or
b) Click the
Configure Device
button to make changes to the normal
configuration.
The Edit Default Configuration window opens. It is similar to the Tools >
Options > Configure command in the Epiphan Capture Tool.
Figure 21 Edit Default Configuration window
4. Edit the parameters.
5. Click OK; the Edit Configuration window closes and the Epiphan Frame
Grabber Configuration window reappears.
6. Perform one of the following:
7. Click the
Default Configuration
button to make changes to the default
configuration; or
8. Click the
Configure Device
button to make changes to the normal
configuration.
9. Select the
Use default configuration parameter
radio button to activate
settings.
10. Click
Close
.
To edit device-specific configuration:
53 SDI2USB 3.0 User Guide