Standalone VGA Grid User's Guide

Standalone VGA Grid User Guide
Configure a static IP address
Table 14 DHCP Fields
Label Description/Options
Use DHCP Select this radio button to dynamically obtain an IP address at boot up.
Use static
address
Select this radio button to use the configured static IP address.
MTU Size
The maximum transmission unit (MTU) specifies the maximum packet size for transfer on
the network. The default value is 1500, which is the largest value allowed by Ethernet at
the network layer. It’s best if all nodes in your network use the same value, so only change
this value if you know other nodes use a different value.
Configure a static IP address
Your network administrator may require you to use a static IP address for your Standalone VGA Grid.
To configure a static IP address:
1. Login to the Admin panel as admin. See Connect to the Admin panel.
2. Select the Network link in the Configuration menu; the network configuration page opens.
3. Select the radio button use static address, if not already selected.
4. Enter the desired IP Address and Network Mask.
Only IPv4 addresses are supported.
66