Standalone VGA Grid User's Guide

Standalone VGA Grid User Guide Step 5: Testing the stream
You may now optionally add audio to your channel:
7. Click Sources for your channel; the media source page is displayed.
8. Select the audio source to which you connected your 3.5mm audio cable. If you connected to the blue
line-in on the back of the system, the audio source is the audio source without a frame grabber serial
number.
9. Click Apply.
10. Click Encoding for your channel; the Encoding page is displayed.
11. Scroll to the bottom of the Encoding and click the Enable audio checkbox.
12. Leave the default AAC format and audio bitrate.
13. Click Apply.
Step 5: Testing the stream
The Status page contains a link to the live broadcast stream for your channel.
To preview the channel in a browser:
1. From the Admin panel, scroll to the Channels section.
2. Click the link for your channel.
3. Click the Status link for your channel.
4. Right-click on the Live broadcast link for your channel and select Open in a new tab or Open in a
new window.
5. The new tab or window opens with the stream displayed.
a. If the signal is not detected, reset the DVI cable connections and try again.
Your stream setup is complete. Since most of the steps are pre-configured; you are up and running with a
stream very quickly. You can share the live broadcast link with your users.
24