Standalone VGA Grid User's Guide

Standalone VGA Grid User Guide Step 3: Set up the video source
http://<serial>.local/admin
For example: http://95dd40d5.local/admin
3. Enter the user name and password then click OK. The administrative user is ‘admin’. Initially no
password is set. To set a password follow the procedure outlined in User administration.
4. Optionally, navigate to the Network link under the Configuration heading and note the IP address of
the system.
Step 3: Set up the video source
The Admin panel has a pre-configured list of the frame grabbers in the Sources section. Each video input card
on the back of the system is a frame grabber. Each frame grabber has one DVI port, one SDI port, one S-Video
port and one 3.5 mm audio port. The sources are listed by their frame grabber serial number.
DVI ports are listed with the suffix .vga, SDI ports are listed with the suffix .sdi, S-Video inputs listed with the
suffix .video, and analog audio inputs are listed with the suffix _analog or, for the audio port on the
motherboard:Analog. Digital audio inputs (for systems with SDIports) are listed with the suffix .hdmi-audio
or .sdi-audio, depending on their source.
The serial numbers for your system will not be the same as the examples shown below.
1. From the Admin panel, scroll to the Sources section. (You will see more sources than shown below.)
21