User's Manual

CDMA FWT SXT-2180 11 Technical Manual
SXT-2180 TECHNICIAN PROGRAMMING
Technician Programming Commands
CDMA WIRELESS LOCAL LOOP 1X TERMINAL SERVICE MANUAL(SXT2180)
I. Entering service mode(NAM mode)
1. Pick up the handset.
2. Press “*748#96*75259#”, then you can hear a confirmation tone.
3. Press “000000”(security code), then you can hear a confirmation tone.
Now, you are in a service mode.
Current state is the main state.
If you press wrong code, you can hear an alert tone.
And then you will be in idle state.
If you enter the service mode again, start again from ‘1’.
*Note: If a user wants to go out the service mode while he is in a main state, press “**” or take down the
handset. Then the terminal will be reset. You can see the read-only data and changed data via Virtual LCD.
II. Quick Reference Table for Technician Programming.
CATEGORY ITEM SHOTKEY FUNCTION
ESN(01)
(Electronic Serial Number)
“0101”
Read Only
Press À or #, then Confirmation
tone is heard. Go to main state.
CAI Ver(02)
(Common Air Interface)
“0102”
Read Only
Press À or #, then Confirmation
tone is heard. Go to main state.
WILDCARD(01)
“010301”
Press À: go to main state after
save.
Press #: go to main state.
VoiceSO(03)
EVRC(02)
(Enhanced Variable Rate
Codec)
“010302”
Press À: go to main state after
save.
Press #: go to main state.
SCM(04)
(Station Control Mark)
“0104”
Edit as “0”,”1”
Press À: go to main state after
save.
Press #: go to main state.
LOCK CODE(05)
“0105”
Read Only
Press À or #, then Confirmation
tone is heard. Go to main state.
SLOT MODE(06)
“0106”
Press À: Slot mode.
Go to main.
Press # :None Slot mode. Go to
main
SLOT CYCLE INDEX(07)
“0107”
Set slot cycle index when the
SXT800 is in slot mode.
Edit as “0”~”1”
Press À : go to main state after
save.
Press # : go to main state.
RC(08)
(Radio Configuration)
“0108”
Edit as “1”~”5”
Press À : go to main state after
save.
Press # : go to main state.
General (01)
SPC CHANG(09)
“0109”
Press À : enable
go to main state.
Press # : disable