User's Manual

SIT SXT-2080 Fixed Wireless Terminal
CDMA FWT SXT-2080
Rev.01.2.SM.SC.11.09.05
7 User Guide
Flash time ‘##33’
- In the Flash time menu, you can determine flash time in the range of 50~800 ms.
- If the designated flash time exceeds 800 ms, then such inputs will be ignored.
- Press ‘À’ to activate. Or press ‘#’ to deactivate.
Ex)
##3 + 300 + À : to activate a flash time to 300 ms
Flash time ‘##33’
- In the Flash time menu, you can change flash time from 50 to 999 ms.(default : 100 ms )
- If entered time is out of ranges, it will be ignored.
- And if entered time is more than the on hook time, it will be ignored as well
- You can not set bigger value than on-hook time.
If you want to do so, please first adjust on-hook time and then, set a flash time
- Press ‘À’ to set. Or press ‘#’ to release.
Ex)
##33 + 300 + À : to set the flash time to 300 ms
On Hook time ‘##34’
- In the On Hook Time menu, you can change the on hook time from 101 to 1000ms( default : 500 ms )
- If entered time is out of ranges, it will be ignored
- And if entered time is below than the flash time, the time will be ignored as well
- You can not set smaller value than the flash time.
If you want to do so, please adjust a flash time first, and then, set an on-hook time
- Press ‘À’ to set, Or press ‘#’ to release.
Ex)
##34 + 500 + À : to set the on hook time to 500 ms
. Ⅴ Activateting Menu
New Code ‘##41’
- You can change a lock code - ‘0000’ is the factory default value.
- Press ‘##41’, to enter the lock code menu and a prompt sound will be heard immediately.
- Press the default value or previously programmed code to confirm the current security setting.
- If the lock code input is correct, then a confirmation tone will be heard.
-.First, you have to enter new lock code and press ‘À’ key and second, you have to enter that lock code
again to make a double check and press ‘À’.
- If first code and second code is a match, a confirmation tone will be heard. If the codes are different,
you will need to input them again from the beginning. Simply put down the receiver and try again.
- Or press ‘#’ to cancel to cancel this procedure.
Ex) Suppose a current lock code is ‘7777’, and the user wants to change this to ‘8888’.
##41 Î a lock-code prompt sound Î 7777 Î a confirmation tone Î 8888 Î Press À Î 8888 Î
Press À Î a confirmation tone
Restrict outgoing ‘##42’
- You can restrict outgoing call to protect someone from call outgoing without your permit.
- You can activate a restriction on by pressing ‘À’.
- Press ‘#’ to cancel what you did.
Master Clearing the phone ‘##43’
- You can clear all parameter values of this terminal to factory values.
- Press ‘À’ and a FWT will be cleared to default values.
- Press ‘#’ to cancel.