User Manual

CDMA 1x WLLPhoneCDMA 1x WLLPhone
42
• TO START A DATA OR FAX CALL
Note: The restrict calls feature may affect any data/fax calls you attempt.
If you experience problems, check your call restrictions.
1 Initiate a data or fax call using your data or fax software configured for your phone.
2 When trying to connect to the network, the phone displays Connecting... Once
connected, the text Data call (or Fax call) remains on the display for the duration
of the data or fax call.
3 Terminate the data call from your data software; fax calls typically terminate
automatically.
Note: Avoid terminating a call by pressing the End key. This may cause your data or
fax application to temporarily lock up and could cause loss of data.
Note: Data or fax calls cannot be initiated using your phone’s keypad. All data and
fax calls must be initiated using the data or fax software.
Note: Any touch tones (DTMF tones) needed for calling cards, special long-distance
access numbers, etc. must be programmed into the dialing string.
• TO RECEIVE A DATA OR FAX CALL
Your phone must be connected to your PC via the data cable.
1 The appropriate data or fax software must be running. Consider setting your data
or fax software to automatically answer incoming calls so you can receive them
while away from your PC.
2 When you receive a call, Data call or Fax call appears and an alert sounds.
3 Terminate the data call from your data software; fax calls typically terminate
automatically.
Note: This feature is available only if your service provider’s network supports data
and fax calls. Data and fax calls may also require that you subscribe to these
additional services. Please check with your service provider before sending or
receiving data or fax calls. Your phone can function as a fax/modem when
connected to your PC or laptop computer via the optional 9-pin RS-232 Data Cable
(available through your local Sungil Telecom dealer or any nearby Electronic Shops).
You must also have the appropriate fax or data software installed and configured to
send and receive data or faxes through your phone.
Note: Although your phone is capable of data transmission rates up to 14.4 Kbps,
your actual transmission rate may vary, due to your service provider’s network.
Please check with your service provider for actual data transmission rates.
• GETTING STARTED
Make sure your phone is connected to your computer via the optional RS-232C Data
Cable and your computer recognizes the new hardware.
See the installation and configuration instructions supplied with RS-232C cable for
more information.
• CONFIGURING YOUR DATA OR FAX SOFTWARE
Once properly connected and configured, your PC will recognize your phone as an
external fax/modem. However, your fax or data software may already be configured
to use the existing PCMCIA or internal modem.
Before you can use your phone to send and receive data or faxes, you must
reconfigure your fax or data software so that it uses your phone rather than your
existing modem. You may consider creating a separate set of dialing properties to
use when your phone is connected, rather than changing any existing settings.
Please refer to the documentation or online help files for your data or fax application
when creating new dialing configurations, or modifying existing settings.
41
Data and fax calls
• BATTERIES AND CHARGERS